Products forced convection glass tempering furnace is divided into: the upper fan convection, heat up the circulation of hot air blower convection and forced convection toughened furnace principle: this series of products according to the principle of convection heating, the use of special design of the convection fan and original structure of hot air circulation, and adopts many advanced technologies, make glass surface heating accelerated dramatically, greatly increased the production efficiency and product quality, especially in the processing of low-e glass has incomparable advantage.

Advantages 

1. Adopt separate design of overhead high efficiency circulating heat blower

2. frequency conversion accurate control of air to ensure that the glass heating quickly uniform heat

3. High temperature resistance, oxidation resistance, high quality stainless steel convection system

4. clean and efficient, not easy to deformation, long service life

5. Soft shaft adopts the latest soft shaft materials at home and abroad

6. Unique and reasonable design concept

7. Frequency conversion control, accurate and stable response speed

8. Simple operation and easy maintenance

Toughened glass type 

1. offline

2. online low-e glass

3. Ultra-white glass

4. Screen printed glass

5. Embossed glass

6. Stained glass

7. white glass

Main parameters

Note: 1. The data in the table are calculated according to 5 mm white glass and 100% loading rate;The actual data varies with the glass varieties, specifications and loading conditions.

2. Other models are not listed in full

3. The company reserves the right to change relevant parameters after technical update

At-taq glass tempered furnace is mainly used for processing glass products in building, furniture, home appliances, decoration, automobile and other industries.

Operation points

1. The forced convection tempering furnace must not switch working mode in the production process, which may lead to serious logic errors, resulting in the loss of the glass state, and the glass will remain in the furnace.

2. The forced convection tempering furnace must not use the glass with a large length difference to work at multiple stations, which may cause the glass position in the furnace to be deranged, resulting in too large fluctuations in the position of the furnace, and the general size is controlled within the range of 50mm.If you choose a new specification, you must wait until all products of the previous specification are out of the oven before the next production.

3. The equipment must be put into the system standby mode when the forced convection tempering furnace is undergoing maintenance, so that part of the equipment can be manually controlled, but the system will not automatically run the automatic continuous operation of the production process.

4. the forced convection furnace system maintenance must do a good job of safety protection, in important departments must be necessary when you can press the emergency stop button or cut off the power supply.